Step #1

Allow at least three ribs of Kerfkore prior to beginning of curved area.

Step #2

Allow laminate to extend 2" - 3" beyond Kerfkore.

Step #3

Butt or overlap and under scribe laminate seam.

Step #1

Allow approximately 5/8" of facing material to extend beyond both pieces of Kerfkore.

Step #2

Trim laminate to 1/2" with router to obtain a good seam edge.

Step #3

Butt laminate together and clamp in place.

Step #4

Adhere a strip of vertical grade HPL over seam using a rigid setting adhesive such as epoxy.

Step #5

Cut seam rib 3/4" wide from solid wood or particle board.

Step #6

Apply contact cement to seam rib and adhere to back of vertical HPL strip as applied in step 4 above.