| |
CAUSE
|
REMEDY |
| A |
Wrong solvent blend. |
Usual remedy is to choose a slower evaporating
thinner. |
|
B |
Atomizing air pressure too high. |
Use least amount of compressed air necessary. |
| C |
Over reduction of material. |
Use less reduction. Add fresh material to that
which has already been over reduced. |
|
D |
Gun held too far from surface. |
Hold gun at proper distance, usually 6-10 inches,
from work. |
| E |
Spraying past surface of the product. |
Release trigger when gun passes target. |
|
F |
Wrong air cap or fluid tip. |
Ascertain and use correct combination. |
| G |
Fluid pressure too low. |
Increase fluid pressure. |
