| |
CAUSE
|
REMEDY |
| A |
Unclean
conditions of application areas.
|
Cleanliness. Rearrange equipment so that any
spray dust from booth does not reach drying chambers. |
|
B |
Improper solvent which tends to throw resin out
of solution. |
Use the proper recommended thinner. |
| C |
Material has been subjected to extreme cold which
tends to throw some particles out of solution. |
Allow material to reach 750 F before applying. If
still seedy, consult your coatings supplier. |
|
NOTE: Always check coating with a magnifying
glass to be sure there is dirt in film instead of small air bubbles.
Pour coating on a clean surface like glass to assure finish is not seedy
or has dirt in finish. Let it dry in a dust free area. Any contamination
will show up when glass is held up to light. |
