|
Step
#1
Connect the gun to the hose and
then connect the hose to the tank
|
|
|
 |
 |
|
Step
#2
Turn tank on and leave it on at
all times to ensure that no drying will occur in the hose or the gun
|
 |
|
Step
#3
To adjust
the spray width, use the wheel located behind the trigger. For larger
pieces, spray should be approximately 5" width.
|
 |
|
Step
#4
Spray the
laminate in one direction and then spray the particle board in the
opposite direction so that lines overlap each other.
|
|
 |
|
Step
#5
Wait for
1 - 2 minutes until tacky dry.
|
|
Step
#6
Apply
laminate to the particle board and then "J" roll the entire
surface.
|
|
|
 |
|
Step
#7
Product
can be filed or cut immediately. It will take approximately 24 hrs to
completely cure |
 |
